The product can be used on wood and fabric. Plastic and metal are non-absorbent materials that cannot be treated. Overspray of product on these materials should be wiped off with a damp water cloth.
It remains effective for five (5) years on textiles or until the fabric is water washed or three dry cleanings. After cleaning it must be reapplied. It will not leach out of lumber unless exposed to continuous high humidity. The product can be sealed into lumber by top coating with a non-flammable paint or varnish.
Lumber should be free of dust or loose soil, paint, varnish or other previously applied coatings. A nonflammable surfactant may be used to pretreat lumber for deeper penetration of the product into the lumber.
No once applied and cured. Product should be stored out of direct sunlight between 2◦C and 37◦C.
It can be used on raw uncoated lumber and gypsum.
It remains effective for five (5) years on textiles or until the fabric is water washed or three dry cleanings. After cleaning it must be reapplied.
It prevents and slows down the progression of flame spread. It does not impart thermal barrier resistance.
Non-corrosive metals will not be affected. Overspray on metals subject to corrosion or rust should be wiped off with a damp water cloth
Yes, it has been tested in safety and security laboratories in the U.S.
It becomes fully effective after 24 hours of treatment.
Yes, it complements them.
Yes.
Yes, but it is not used on non-corrosive metals.
Yes.
Yes.
The material has no relation to smoke.
No.
No.
Yes, but after inspection.
It penetrates effectively to enhance fire protection.
No.
No, but it is recommended to conduct a small test to ensure there are no unwanted effects.
It is easy to clean using water only, without chemical cleaning agents.
Yes.
No.
No.
Yes, but after inspection.
Yes, it has been tested by entities such as the U.S. Federal Aviation Administration, NASA, and fire departments in New York and California.
No, materials can be painted or formed after treatment without any effect.
It can withstand up to 1400°C.
It prevents flame spread and is fire-resistant.
No pre-treatment is required, but the material should be wet with water.
It can be used on both new and existing materials.
It requires reapplication after 5 years.
It remains effective for 5 years.
It does not require good ventilation and is safe for use in enclosed spaces.
No, the product is environmentally friendly, and no safety precautions are needed.
Yes, it can be used on these materials and does not affect their color or texture.
It can be used on non-combustible materials such as wood and gypsum.
It can be used on non-combustible materials such as wood and gypsum.
Yes, it can be used on these materials and does not affect their color or texture.
No, the product is environmentally friendly, and no safety precautions are needed.
It does not require good ventilation and is safe for use in enclosed spaces.
It remains effective for 5 years.
It requires reapplication after 5 years.
It can be used on both new and existing materials.
No pre-treatment is required, but the material should be wet with water.
It prevents flame spread and is fire-resistant.
It can withstand up to 1400°C.
No, materials can be painted or formed after treatment without any effect.
Yes, it has been tested by entities such as the U.S. Federal Aviation Administration, NASA, and fire departments in New York and California.
Yes, but after inspection.
No.
No.
Yes.
We’re ready to help you to answer any questions.
Al nafud fire retardant lining materials Office No A-317-18 Roof Floor. A Block Saraya Avenue Building. AL Garhoud. Deira. Dubai UAE
Copyright © 2025 All Rights Reserved.
